EBurg
Well-Known Member
Hey folks -
Working on a project that won't be easy to use electronics for deployment. Has anyone had luck drilling out a K550 down to a delay of <6 seconds? Ideally I'd like to get to 4 seconds. No problem using a drill bit to get there but wondering if there will be enough delay grain to hold in the pressure.
Thanks!
Eric
Working on a project that won't be easy to use electronics for deployment. Has anyone had luck drilling out a K550 down to a delay of <6 seconds? Ideally I'd like to get to 4 seconds. No problem using a drill bit to get there but wondering if there will be enough delay grain to hold in the pressure.
Thanks!
Eric