billdz
Well-Known Member
- Joined
- Feb 10, 2017
- Messages
- 1,377
- Reaction score
- 121
During yesterday's launch, two of my rockets landed on an asphalt road. A fin was chipped on one, the point of the fiberglass nose cone was chipped on the other, pics attached.
For the NC, should I just sand off the damaged point and repaint, or what? For the fin, can I place sheets of paper over the area where the wood is missing and then fill with epoxy or something? Or do I need a whole new fin?
Thanks for any tips or tricks,
Bill
For the NC, should I just sand off the damaged point and repaint, or what? For the fin, can I place sheets of paper over the area where the wood is missing and then fill with epoxy or something? Or do I need a whole new fin?
Thanks for any tips or tricks,
Bill