SCP
Well-Known Member
- Joined
- Jun 23, 2011
- Messages
- 435
- Reaction score
- 48
Anyone have any recent experience 3D Scanning or otherwise digitizing/reverse engineering? I need to get some complex geometry into Solidworks to finish up some documentation and want to take advantage of this potential short cut as I don't need very high accuracy at this stage.
Looking at the consumer grade "Sense" by 3D systems, which, usually consumer grade stuff scares me. But again I dont NEEd that high accuracy. Anyone tried the Sense scanner?
Or similar?
Cant be a turntable, as the part is larger than most lazy susan scanners I see.
And photogrammetry technique is not resulting in a very usable model as of yet. I am using 123D .... and although I dont need very high accuracy, this is inadequate in trials so far. I could deal with +/- a whole millimeter probably at this early stage of this project.
Interested to hear any experience / thoughts.............
Looking at the consumer grade "Sense" by 3D systems, which, usually consumer grade stuff scares me. But again I dont NEEd that high accuracy. Anyone tried the Sense scanner?
Or similar?
Cant be a turntable, as the part is larger than most lazy susan scanners I see.
And photogrammetry technique is not resulting in a very usable model as of yet. I am using 123D .... and although I dont need very high accuracy, this is inadequate in trials so far. I could deal with +/- a whole millimeter probably at this early stage of this project.
Interested to hear any experience / thoughts.............