Hi Ricky,
Single sided,
View attachment 559582
or two sided,,
View attachment 559583
I need the distance from the top centering ring to the top edge of the booster..
Any attachment point should not reach out of the booster...
Something is going to wear against the sharp edge of the booster,,
that can be the built into the rocket “Y” attachment point that is very difficult to access/service,,
or what wears can be the very easy to access/service booster harness…
This is why I keep these attachments short enough so they don’t reach out of the booster…
It’s things like this that make my harness set ups outlast rocket after rocket…
When you email me it's important that you include the answers to these questions..
Hi XXXX,,
How are you ?
My name is Ted Chernok.
It’s very nice to meet you.
Yes, of course I do custom work..
I can make any configuration you need..
I’ll need to know a few specs on the rocket for us to begin.
Just answer in red right next to each item,,
It’s easiest that way..
What’s the material, fiberglass ??
What’s the diameter of the airframe ?
What’s the diameter of motor mount ?
What’s the distance from the top centering ring to the top edge of the booster ??
What's the length of the booster ??
What’s the length of the payload section ??
What’s the all up weight of the rocket, ready to fly, on the pad ??
And at apogee with an empty motor case ??
Is the rocket of a “standard “ configuration,,
separates at the booster for drogue deployment
and at the nose cone for main deployment ?
Have you started construction yet ?
When I have these answers I can make a harness setup recommendation for your rocket..
It's critically important that you understand,
You asked a question that had a grand total of a dozen words in it.
In order for me to help you the reply contains a few paragraphs that take much time and effort to put together.
I do this in order to make a correct recommendation of a harness set up for you..
If I can help, yus hollar,, lol..
Teddy