Kruegon
Well-Known Member
- Joined
- May 20, 2014
- Messages
- 1,885
- Reaction score
- 5
I posted about building some launch controllers a while back. I got a ton of help with schematics and explanations. And I've been reading and learning. I think I'm ready to try building one. Ok, two actually. One relay based system and one more traditional system. Both will be four pads per bank. The first (relay) will be two banks, eight pads total. The second (non-relay) will be three or four banks (depending on available selector switch) for 12 or 16 pads, respectively.
I am having a hard time locating the proper parts. Where do you guys get your parts?
So here are the parts I still need:
Toggle switch (on-off) capable of 12v with the silver "stick" style lever. Does Amp rating matter here?
Rotary selector switch capable of 12v, with a hand knob, with one input and two output, and a second one with the same specs but one input and 4 output. (three is acceptable, but four is prefered). Again, appropriate amp rating?
Red LED lights with a built in resistor, to use for continuity, the is made to be panel mounted. And I'm not sure what the resistance should be on this.
The rest I think I have figured out. Although I'm not counting my chickens just yet. Thanks guys.
I am having a hard time locating the proper parts. Where do you guys get your parts?
So here are the parts I still need:
Toggle switch (on-off) capable of 12v with the silver "stick" style lever. Does Amp rating matter here?
Rotary selector switch capable of 12v, with a hand knob, with one input and two output, and a second one with the same specs but one input and 4 output. (three is acceptable, but four is prefered). Again, appropriate amp rating?
Red LED lights with a built in resistor, to use for continuity, the is made to be panel mounted. And I'm not sure what the resistance should be on this.
The rest I think I have figured out. Although I'm not counting my chickens just yet. Thanks guys.