Kruegon
Well-Known Member
- Joined
- May 20, 2014
- Messages
- 1,885
- Reaction score
- 5
Before I start:
Please do not post anything that could get any of us in trouble. No formulas, no ingredients, nothing.
With that being said, the questions are simple. I could probably locate this info on the web, but I didn't have any success in my searches.
Very soon I'm going to be getting into EX. I've already started working on a basic understanding. As I won't have my L2 until at least February, I cannot gain access to the research forum. Nothing I'm asking will break the law.
I know you can use Loki, AMW, and Gorilla motors for EX loads. Are there any other motors that can be used?
Loki has reusable nozzles. Do any of the others offer this,
My experience with RMS is strictly Aerotech. There are washers and o-rings in them. Do the snap ring motors use these? Are they some special order item or can they be obtained normally?
I've seen pictures of the mixing being done in kitchen aid mixers. I've heard tale of a shaking table. I know there's a mandrel used to create the core. Is there any other equipment required that I could start purchasing ahead of time?
I know they are packed into liners then cut to length. Is there two liners like with AT motors? One the grains are packed and formed in and a second one to line the motor case?
That's it. If there's anything else that I need to know ahead of time, fill me in. Just please don't get us in trouble.
ADMIN: By everything I have read and checked, these questions are not an issue from any legal standpoint. If you do not agree, feel free to delete. I won't be offended. I just want to be prepared as much as I legally can.
Please do not post anything that could get any of us in trouble. No formulas, no ingredients, nothing.
With that being said, the questions are simple. I could probably locate this info on the web, but I didn't have any success in my searches.
Very soon I'm going to be getting into EX. I've already started working on a basic understanding. As I won't have my L2 until at least February, I cannot gain access to the research forum. Nothing I'm asking will break the law.
I know you can use Loki, AMW, and Gorilla motors for EX loads. Are there any other motors that can be used?
Loki has reusable nozzles. Do any of the others offer this,
My experience with RMS is strictly Aerotech. There are washers and o-rings in them. Do the snap ring motors use these? Are they some special order item or can they be obtained normally?
I've seen pictures of the mixing being done in kitchen aid mixers. I've heard tale of a shaking table. I know there's a mandrel used to create the core. Is there any other equipment required that I could start purchasing ahead of time?
I know they are packed into liners then cut to length. Is there two liners like with AT motors? One the grains are packed and formed in and a second one to line the motor case?
That's it. If there's anything else that I need to know ahead of time, fill me in. Just please don't get us in trouble.
ADMIN: By everything I have read and checked, these questions are not an issue from any legal standpoint. If you do not agree, feel free to delete. I won't be offended. I just want to be prepared as much as I legally can.