- Joined
- Jan 11, 2013
- Messages
- 6,451
- Reaction score
- 963
hey,, nice pic,,
comon,,
cough em up..
Teddy
kkkk,,
I'll bribe ya..
comon,,
cough em up..
Teddy
kkkk,,
I'll bribe ya..
hey,, nice pic,,
comon,,
cough em up..
Teddy
kkkk,,
I'll bribe ya..
lol I've got a million, but I can't tell blue thunder from loki blue in most....hard to pick through and find the right ones.
Look really, really, REALLY close..
you can tell..
There's a nice bribe in this for you...lol...
Finally got the refund back to Paypal.
I don't wish Dave ill will but dude! Shut it down or something!
What does a red arrow represent anyways! Native Indian's revenge?
Folks, can we keep the comments civil, specific, fact-based, non-speculative?
1x H170-14 |
1x H178-L |
1x H268-M |
1x I200-M |
1x J1299-P |
1x J460-L |
1x J510-M |
1x J570-M |
1x K1050-P |
1x K1103X-L |
1x K456-L |
1x K540-L |
2x H148-M |
2x H210-M |
2x I327-L |
2X J340-L |
2X K1100-L |
Wow, quite the order!
This (the thread, not the posted order) makes me think.. What is the Paypal's policy when a vendor starts to get multiple complaints / claims against him...
Hello Steven, sorry to hear you had a completely different experience with your Saturn V kit that I had. I just purchased this kit from RAH this last August. I thought it was a pretty nice kit. I had very detailed instructions included in my kit. My Apollo module, LES, fin shrouds, and really all the resin castings seem to be quite good quality and detailed. I thought I would pass this on in case it may be helpful, the resin shrouds ( and other resin parts) can get a little warped from transit and storage, but can be easily made to fit by applying a little heat (hot water, heat gun, or microwave for a few seconds). Some decals and wraps need to be cut or trimmed a little, but this usually is common in many scale kits I've put together. All in all I think it is a very nice detailed well thought out kit, the only changes I would make is to use FW fiberglass for the airframe tubes and motor tubes, and G10 for the fins and centering rings instead of the plywood in case it lands on wet ground, snow mud, or a puddle, but I'm sure would add some cost and I'm just a fiberglass type guy, but the kit description and photos look exactly like what I received. Good luck on your build.
Look at my build of this kit in the mid power section if you haven't already. You'll find all of the maladies I listed in this section. Look at the resin pieces I purchased from another vendor and compare them to RAH's pieces. You'll see a marked difference. The CM would NOT fit in the SM tube! THAT pissed me off! I straightened out the warped fin shrouds by using a heat gun yet were still too warped for fitting properly AND having proper fin alignment. The fact that you feel you got a decent kit while I got a poor one will not negate the fact that at best, his practices and service are hit and miss at best.
Yes Dave makes the S.H.R. kits.
Well den! Dave he no got functional compacity comunacative skills.
I got an "out of service" message when I called him. turns out he was "out of cellular range" for a few days..
Enter your email address to join: