bdureau
Well-Known Member
- Joined
- Dec 20, 2011
- Messages
- 539
- Reaction score
- 246
I have built a full plastic rocket that I am planning to fly with an H motor.
Appart from the body tube and the motor mount all the other parts are 3D printed
It is 1.20 m hight, weight about a kg an the diameter is 50mm
It is a dual deployment rocket with 2 altimeters (one is used for redondancy).
I have not used any glue only nuts and bolts, most of the holes were 3D printed so it is the kind of rocket you can build your sofa with limitted tools.
Which is good when you leave in a flat.
It tooks about 50 hours to print
The idea is to see what can be 3D printed in a rocket
Appart from the body tube and the motor mount all the other parts are 3D printed
It is 1.20 m hight, weight about a kg an the diameter is 50mm
It is a dual deployment rocket with 2 altimeters (one is used for redondancy).
I have not used any glue only nuts and bolts, most of the holes were 3D printed so it is the kind of rocket you can build your sofa with limitted tools.
Which is good when you leave in a flat.
It tooks about 50 hours to print
The idea is to see what can be 3D printed in a rocket