GRIFFIN
Well-Known Member
- Joined
- Aug 24, 2009
- Messages
- 3,222
- Reaction score
- 132
Finishing up:
Install the rail buttons. Be aware that the gap in between the nose cone shoulder and the boat tail shoulder is less than 1/2". Measure carefully and place the forward button in between the gap of the two shoulders. The lower one can go at the lower end of the body tube.
If you decide to use a launch lug, glue it on with epoxy and center it as needed.
I also drilled a small (1/8") vent hole just above the forward button.
Install the rail buttons. Be aware that the gap in between the nose cone shoulder and the boat tail shoulder is less than 1/2". Measure carefully and place the forward button in between the gap of the two shoulders. The lower one can go at the lower end of the body tube.
If you decide to use a launch lug, glue it on with epoxy and center it as needed.
I also drilled a small (1/8") vent hole just above the forward button.