blackjack2564
Crazy Jim's Gone Banana's
If you are building one of these 2-stagers, you will find extreme difficulty in mounting a conduit small enough, to run wire through centering rings for sustainer ignition. H.E.I. is the way to go.
We are in the midst of a run making these CTI/AT and if you have any interest in these, varying sizes,29mm 38mm etc.
Apparently that thread has been moved to another dimension. So PM me with any needed info wanted.
...............................................................................................................................................................
Jan 18 2018.
Well I finally got my camera back after it went by Savannah twice ending up in Jacksonville, then past me again on the way to North Carolina...LOL Finally back to Jacksonville then landing on my doorstep 3 weeks after being shipped 3 day priority.....LOL So here we go:
Pics were taken last month, just hadn't loaded them on computer.
Well packed parts, I was surprised so many came wrapped tightly in paper, NC, Transition,& most small delicate type parts. Fins/rings all bagged or wrapped..impressive!
Reminded me of my first Binder Kits that were also shipped very well!
Layout of all parts in groups of the build:
First to be changed is the I/S:
comes with just the transition-coupler - centering ring.
I'm adding stepped av-bay BP's to which the CR & glued in Coupler will sandwiched together by the threaded tie rods going through bay.
Here's the 3D printed scale version. Hard to believe it's printed. It was annealed at 185F for 4 hours, to toughen it up for all you worried about it, "taking the heat" LOL.
Complete with stainless bolts and accurate vent placements! This will be for my true scale version later, I will build/ fly the stock one on this build so everyone can play too. Blow it up all the way [clk 3x's] see how smooth & detailed. The 38 coupler is carbon, NOT printed.
So now the fun begins over next few days/weeks!
Last edited: