geof
Well-Known Member
- Joined
- Feb 15, 2009
- Messages
- 1,277
- Reaction score
- 0
I forget. Is the rule of thumb to remove 1/16in per 1sec with 1/8in drill bit???
[Also, just out of curiosity, why isn't it L/n inches per sec reduction, where L is the physical length of the delay component and n is the default seconds of delay?]
Geof
[Also, just out of curiosity, why isn't it L/n inches per sec reduction, where L is the physical length of the delay component and n is the default seconds of delay?]
Geof