Greetings!
I'm slowly but surely putting together my LOC/Precision 7.5" Doorknob. I have found that the centering ring forward fin attach point has warped. Flattening one side against the table, I've about 4 or 5mm warpage on the opposite side. Is there a known good method for flattening large centering rings? My thought process only is taking me to 'put heavy weight on it for a couple of days' and then immediately glue it to the motor can before it can 'find' its memory. Perhaps I could glue one 120 degrees or so, let it dry then glue the rest? Soaking in warm water? Any ideas would be greatly appreciated - thanks!
Mark!
I'm slowly but surely putting together my LOC/Precision 7.5" Doorknob. I have found that the centering ring forward fin attach point has warped. Flattening one side against the table, I've about 4 or 5mm warpage on the opposite side. Is there a known good method for flattening large centering rings? My thought process only is taking me to 'put heavy weight on it for a couple of days' and then immediately glue it to the motor can before it can 'find' its memory. Perhaps I could glue one 120 degrees or so, let it dry then glue the rest? Soaking in warm water? Any ideas would be greatly appreciated - thanks!
Mark!