Will it have the same dimensions of telemini V1.0?We're building TeleMini v2.0 this month, hoping to get them in the store for April. It's the same width as TeleMini v1.0, but a bit longer so I could add two more mounting holes past the pyro screw terminals. The new version has an ARM processor, 512kB of flash for flight data recording, a 40mW transmitter and should have the ability to talk over USB with an adapter board if I can get that to work. Oh, and it has a beeper now, instead of a light, which will make it possible to hear the altimeter on the pad and on the ground.
Will it have the same dimensions of telemini V1.0?
Approx. wt. increase?
Oh ok.and note that you can shorten it back to 1.5 inches if you don't need the aft screw terminals. There's a PDF file with an outline of the board and screw hole locations available. Print that out and you should have a fine proxy. Just for completeness, the board is 0.5 inches wide and 1.67 inches long. The holes are 0.085 inches from each edge.
Enter your email address to join: