I'm doing a run of custom aft tail cone closures that fit AT 75mm motors. These are perfect for that minimum diameter M1315 or M1850 project you've got. These closures will function like a standard aft closure in every way, but with the benefit of a tail cone to reduce base drag and increase your rocket's performance.
Specs:
- precision machined from 6061T6 aluminum
- 2.45" total length
- 1.70" exposed tail cone length
- 3.125" max diameter at shoulder
- 2.375" diameter at aft end
- slide over single-throat AT nozzles (not compatible with Medusa nozzles)
- aluminum finish, not anodized
These are not certified at this time and are for research flights only. I am offering these at $99 each, plus $10 shipping to anywhere in the lower 48. PM with interest. Orders will be taken through May 1st. Turnaround time is 4-6 weeks. They will be shipped via USPS priority mail.
Pic below is the 98mm version.
Specs:
- precision machined from 6061T6 aluminum
- 2.45" total length
- 1.70" exposed tail cone length
- 3.125" max diameter at shoulder
- 2.375" diameter at aft end
- slide over single-throat AT nozzles (not compatible with Medusa nozzles)
- aluminum finish, not anodized
These are not certified at this time and are for research flights only. I am offering these at $99 each, plus $10 shipping to anywhere in the lower 48. PM with interest. Orders will be taken through May 1st. Turnaround time is 4-6 weeks. They will be shipped via USPS priority mail.
Pic below is the 98mm version.
Last edited: