Silverleaf
Well-Known Member
- Joined
- Feb 22, 2003
- Messages
- 1,127
- Reaction score
- 1
Howdy,
I posted in another thread that I was building a Quest Tomahawk, and that I replaced the card stock shroud with a styrene duplicate. Much nicer and cleaner looking.
I used Maxi-Cure Cyanoacrylate glue and it bonded instantly to seal the shroud, then I used Great Planes Wood glue with Aliphatic resin to glue the shrouds internal centering ring onto the MM.
So, before I screw up here, my question is:
Which glue should I use to glue the balsa fins onto the styrene shroud ?
I could use Super Glue, laying down a base coat on the balsa first, then drop each into position on the shroud...( touchy situation using this method because I've seen how fast the super glue bonds to the styrene - instant is too slow.) lol
or I could use Bob Smith Industries Epoxy.
I'd try wood glue but I've a feeling it won't bond to the styrene properly.
Any ideas would be greatly appreciated.
Cheers,
R.S.
I posted in another thread that I was building a Quest Tomahawk, and that I replaced the card stock shroud with a styrene duplicate. Much nicer and cleaner looking.
I used Maxi-Cure Cyanoacrylate glue and it bonded instantly to seal the shroud, then I used Great Planes Wood glue with Aliphatic resin to glue the shrouds internal centering ring onto the MM.
So, before I screw up here, my question is:
Which glue should I use to glue the balsa fins onto the styrene shroud ?
I could use Super Glue, laying down a base coat on the balsa first, then drop each into position on the shroud...( touchy situation using this method because I've seen how fast the super glue bonds to the styrene - instant is too slow.) lol
or I could use Bob Smith Industries Epoxy.
I'd try wood glue but I've a feeling it won't bond to the styrene properly.
Any ideas would be greatly appreciated.
Cheers,
R.S.