MysticalRockets
Well-Known Member
- Joined
- Jan 17, 2009
- Messages
- 604
- Reaction score
- 5
Ok, I'm doing a Polecat Spike for my L1. I got it as a door prize at NARCON. (Ok, I got the Bullpup too. But I like how the Spike looks)
I'm having a small issue, and I'm not sure how to proceed.
I built the motor mount, and that was fine. So I decided to dry fit everything. The mount, fins, and the ring.
Here's the problem...
When I dry fit it all, the ring seems to be too large. It touches three of the fins, but there is almost a half inch gap between the fourth fin and the ring. This isn't a "fill it with epoxy" type of gap. Its big.
I really don't want to cut the ring. I'd rather not mess with its structural integrity. Any suggestions?
Bob
I'm having a small issue, and I'm not sure how to proceed.
I built the motor mount, and that was fine. So I decided to dry fit everything. The mount, fins, and the ring.
Here's the problem...
When I dry fit it all, the ring seems to be too large. It touches three of the fins, but there is almost a half inch gap between the fourth fin and the ring. This isn't a "fill it with epoxy" type of gap. Its big.
I really don't want to cut the ring. I'd rather not mess with its structural integrity. Any suggestions?
Bob