XrayLizard
Well-Known Member
Found that an Engraving bit such as supplied with the chinese cnc routers, works very well in this application while handheld in a dremel.
However one needs to first cut a line, through the tube first with an x-acto knife.
The engraving bit then does a good job of following the cut line.
Simple and quick.
***it is not perfect but it is very acceptable to me***
***Your mileage WILL vary. *** lol.
However one needs to first cut a line, through the tube first with an x-acto knife.
The engraving bit then does a good job of following the cut line.
Simple and quick.
***it is not perfect but it is very acceptable to me***
***Your mileage WILL vary. *** lol.