doug_kosty
Well-Known Member
- Joined
- Dec 20, 2009
- Messages
- 93
- Reaction score
- 18
I was looking at an Aerotech 24/40 casing placed in an appropriate sized motor mount tube. It looks to me as though no motor block should be required since the aft closure is larger in diameter than the motor mount tube. Is this reasonable, or would this place too much stress on the threads of the aft closure?
I am aware of the method of making a motor block by wrapping masking tape around the end of the casing, but I am having a hard time seeing the motor distorting the motor mount tube to any large extent.
Just looking for ways to make things neater and more flexible at the same time!
I am aware of the method of making a motor block by wrapping masking tape around the end of the casing, but I am having a hard time seeing the motor distorting the motor mount tube to any large extent.
Just looking for ways to make things neater and more flexible at the same time!