illini
Well-Known Member
- Joined
- Oct 9, 2003
- Messages
- 1,280
- Reaction score
- 0
Here's a fin alignment guide that's so obvious I'm sure its been posted here 3,286 times before. However, since it was an epiphany to me, I'm posting it for the 3,287th time. Requires a protractor and a Black & Decker Workmate or equivalent. Here it is: GENTLY squeeze the tube between the two surfaces of the workmate and use the protractor to line up with the fin mount point. Glue on the fin so that it runs through the origin and 90 degree points on the protractor. Make sure it stays there. Foolproof, although this fool only figured it out today. Here's a pic.