Proposition for some lucky member

The Rocketry Forum

Help Support The Rocketry Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.


Well-Known Member
May 26, 2009
Reaction score
I am in need of an end cap to be made (since I cannot find one to buy- rebel has one but its EITHER 3" or 4") for my nose cone avionics. I have the 3d autocad design made already but need to get it machined or made any way possible, I have no preference. I DO however expect high quality and fine craftsmanship. I am willing to pay well for labor and am hoping someone with those talents might be willing to take a stab at it. The basic concept is a metal bulkhead with threads every 90 degrees around the edge (to fasten it on to the nose cone). It will need to be able to hold an aluminum avionics sled as well. I am open to suggestions etc but I like the idea of a custom high end piece. If you have been following my threads youll have noticed by now that I am very particular about my new model and will spare no expense for good quality work. Thanks all!