Printing Fin Templates

Discussion in 'Rocketry Electronics and Software' started by Davidtmp, Apr 5, 2009.

Help Support The Rocketry Forum by donating:

  1. Apr 5, 2009 #1

    Davidtmp

    Davidtmp

    Davidtmp

    Well-Known Member

    Joined:
    Mar 19, 2009
    Messages:
    810
    Likes Received:
    3
    I'm running Rocksim 7(I know, time to upgrade, but that Arapahoe is first on the list). I'm doing a little designing to play around and get used to stuff. I design a fin that is longer bigger than a sheet of paper. When it prints on another page, there is a margin of like 1/4 inch or so where there is no lines. Do I just need to trim off that margin and tape the pages together where the lines meet?
    David
     

Share This Page