JAL3
Well-Known Member
- Joined
- Jan 17, 2009
- Messages
- 14,333
- Reaction score
- 268
I finally got around to the hardware store an picked up some #4x3/4" screws. I drilled the lug standoff after maring the holes through a linear lug and then screwed each of the 2 screws in. The screws were then backed out and a batch of 5 minute epoxy was prepared. Epoxy was spread on the standoff, the lug was put in place and the screws were tightened. A fillted of epoxy was then run along the joint between the base of the lug and the standoff.