3D Printing PETG-CF

The Rocketry Forum

Help Support The Rocketry Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

thzero

Well-Known Member
TRF Supporter
Joined
Jun 4, 2018
Messages
1,270
Reaction score
902
Just used some Carbon X PETG-CF filament I had hanging around from some time ago. PXL_20230308_204420801.jpg

It was printed on a Bambu X1 Carbon using their hardened steel 0.6 tip and engineering plate with a bit of PVA glue, otherwise used their PETG settings but bumped the temps up slightly 255 for nozzle and 80 for plate.

While the deformation temp isn't that much better than standard PETG, its a heck of a lot stiffer. Parts came out real nice.

I do have some Nylon PA6 Carbon Fiber based filament on the way which is supposed to have higher temp resistance, so we'll see what that prints like.
 
Back
Top