I cannot get OR to show more than 2 transition templates in the Design Report. I am designing an egg capsule composed of 4 cardstock transition elements, nose, body tubes, and transition to the BT-20. The Body Tube sections are cylindrical transitions. Those are the ones that do not show up (sometimes 1 shows up, but not both). Through the design iterations, sometimes 3 of the 4 transition templates show up, sometimes only 2.
Am using 15.03 on a Mac.
Attached is a typical problem file.
Is there a setting, or limitation I am missing in OR? Any ideas?
Thanks,
Don
View attachment Eggloft cardstock B Alt rev 3.ork
Am using 15.03 on a Mac.
Attached is a typical problem file.
Is there a setting, or limitation I am missing in OR? Any ideas?
Thanks,
Don
View attachment Eggloft cardstock B Alt rev 3.ork