REAPER
Well-Known Member
- Joined
- Jan 19, 2009
- Messages
- 129
- Reaction score
- 0
Hey Y'all
It's great having TRF back,thanks to everyone involved for bringing back a great forum.
I need a little help finishing my Polecat 5.5 Nike-Smoke,I'm trying to finish it in time for our (SSS) club launch on Feb 14.
My 1st question; does anyone know what the correct CP is for this rocket??
I looked it up in EMRR and got 2 measurements--55" & 60" from the tip of the NC. The instructions with the rocket clearly state:"The CG should be 55" back from the tip of the NC." I'm confused ???????? Any help would be greatly appreciated.
My 2nd question; would KILZ be OK to fill the fine weave on this rocket. While TRF was down I read about someone doing this on ROL,and I thought this would make it much easier to finish. Any thoughts??????
Thanks for any help.
It's great having TRF back,thanks to everyone involved for bringing back a great forum.
I need a little help finishing my Polecat 5.5 Nike-Smoke,I'm trying to finish it in time for our (SSS) club launch on Feb 14.
My 1st question; does anyone know what the correct CP is for this rocket??
I looked it up in EMRR and got 2 measurements--55" & 60" from the tip of the NC. The instructions with the rocket clearly state:"The CG should be 55" back from the tip of the NC." I'm confused ???????? Any help would be greatly appreciated.
My 2nd question; would KILZ be OK to fill the fine weave on this rocket. While TRF was down I read about someone doing this on ROL,and I thought this would make it much easier to finish. Any thoughts??????
Thanks for any help.
Last edited: