shockie
High Plains Rocketeer
Didn't have any problem straightening out the igniter.
When I tried to push the igniter down the throat, it met some resistance in the core, wouldn't go.
So I took a toothpick and it pushed up all the way. It sure felt like the throat was just a little too narrow, but it went in with no resistance or large force.
Then had no problem pushing the igniter in. I have about 1/4" of the black part of the igniter sticking out of the nozzle.
I'm assuming this is correct.
I think I may get a .020 to .050 carbon fiber rod in the future to test the throats.
Q-Jet A3-4
I'll report back on how it works.
When I tried to push the igniter down the throat, it met some resistance in the core, wouldn't go.
So I took a toothpick and it pushed up all the way. It sure felt like the throat was just a little too narrow, but it went in with no resistance or large force.
Then had no problem pushing the igniter in. I have about 1/4" of the black part of the igniter sticking out of the nozzle.
I'm assuming this is correct.
I think I may get a .020 to .050 carbon fiber rod in the future to test the throats.
Q-Jet A3-4
I'll report back on how it works.