sod4
Active Member
I wanted to share my MX display stands that I've modeled/3D Printed.
They're two-part stands. A common base accepts different arms to provide a selection of 'jaunty' angles. There's also a straight vertical option.
The actual motor insert section is undersized so that I can friction fit it to the motor tube with some tape wraps.
Two of the display stands unassembled (only one base is shown):
The heaviest curve with my in-progress BT-5 Goblin downscale:
The middling curve with my Nike-Cajun (still need to get all the finishing done):
Full Nike-Cajun, just cause I wanted to show you all:
They're two-part stands. A common base accepts different arms to provide a selection of 'jaunty' angles. There's also a straight vertical option.
The actual motor insert section is undersized so that I can friction fit it to the motor tube with some tape wraps.
Two of the display stands unassembled (only one base is shown):
The heaviest curve with my in-progress BT-5 Goblin downscale:
The middling curve with my Nike-Cajun (still need to get all the finishing done):
Full Nike-Cajun, just cause I wanted to show you all: