- Joined
- Nov 24, 2009
- Messages
- 4,674
- Reaction score
- 1,064
Hey guys.
I plan on building a 13mm minimum diameter "double barrel" rocket.
Two A10's.
Three fins on each tube. In four fin configuration, without the fourth fin. Then I will glue the two tubes together at the point where the missing fin is.
I will use 13mm couplers as engine blocks, and use them to hold kevlar strands in the tube, connected to the nosecones, and streamers.
I can't simulate this rocket. Because I only have rocksim V7.
Can someone run simulations for me?
The tubes are 9 inches each, and it uses standard apogee 13mm ogive cones.
Thanks.
I plan on building a 13mm minimum diameter "double barrel" rocket.
Two A10's.
Three fins on each tube. In four fin configuration, without the fourth fin. Then I will glue the two tubes together at the point where the missing fin is.
I will use 13mm couplers as engine blocks, and use them to hold kevlar strands in the tube, connected to the nosecones, and streamers.
I can't simulate this rocket. Because I only have rocksim V7.
Can someone run simulations for me?
The tubes are 9 inches each, and it uses standard apogee 13mm ogive cones.
Thanks.