Looking for someone to troubleshoot and assemble "Egg" products

[ozwald]

Having and issue with my LCD receiver and need two GPS-LCD's assembled... Any pros out there?

 

[Eric]

I build a lot of them, what is the issue with the built one?

 

[ozwald]

Hey Eric. Newer version (B2) was assembled by another member. Can't get to respond, no display? Anyway, I was simply placing the electronics into a blackaero case. Had to hook up switched battery leads and install remote pushbutton on "SW" (I'm assuming that the push button on the board parallels the remote SW contacts?). Anyway, polarity is good, joints look good, etc. Can we continue on email? [email protected]

 

[Eric]

Email sent

 

[OverTheTop]

No display. Have you tried adjusting the trimpot for display contrast? I know a lot of people have found that to be a problem. It was on my LCD build, but a past experience a few decades ago made me go straight for the pot .

 

[ozwald]

It ended being a bad LCD

 

[OverTheTop]

Good you found the problem!

 

[Worsaer]

Hey Oz, glad to hear you figured it out..