Kit ideas for a G80-10

[dr wogz]

Hi all, I have a few G80-10 motors, and I'm trying to find a kit / model that these will pair nicely with. any ideas?

(Yeah, I know.. min dia 3FNC made from helium!)

 

[rstaff3]

Most any min diameter kit. LOC Aura comes to mind. Not familiar withe the fiberglass kits out there. Look at AMW and Wildman to see.

Sent from my SAMSUNG-SGH-I337 using Rocketry Forum mobile app

 

[LithosphereRocketry]

Hi all, I have a few G80-10 motors, and I'm trying to find a kit / model that these will pair nicely with. any ideas?

(Yeah, I know.. min dia 3FNC made from helium!)

They probably are too moistured up by now to be of any use... Better give them to me. :wink:

You don't even need a MD- my Vesta (which will be at the next CRMRC launch) takes full length delays on most motors, and it's 38mm OD. It'll use the full 13 seconds on a CTI 2-grain G68 (I think, I don't have OR up at the moment.) Since it's a CTI motor, I just stick it in the case and I'm ready to launch...

In terms of kits, the Vesta is similar to a beefed-up Star Orbiter. A G80 sounds like a great way to shred a stock one...

 

[aerostadt]

I use to fly the Aerotech Arreaux on the 29 mm single use AT G80-10. If flew great, but the model was hard to see over 2000 feet up. Delay time was just right. Apogee has the Arreaux for about $80. You might be able to find it elsewhere at lower price.

 

[michigander]

G80 CTI skid right ? I fly that in my WM darkstar mini

 

[dr wogz]

Actually, G80-10T single use.. Older ones, without the molded-in motor stop.. Tape, baby, tape it in there!

 

[snrkl]

I’m building (or about to) an apogee aspire to fly on an ATG80-NBT13 DMS...

Taking a 1/4 off the kit airframe length sims at ~1400m and Mach 1.25 (all while carrying an eggfinder mini and a JLA3).

If I add more nose weight I can keep it subsonic and take it past my club’s 5000’ ceiling to 1600m...


Sent from my iPhone using Rocketry Forum