Stymye
Well-Known Member
- Joined
- Jan 21, 2009
- Messages
- 7,599
- Reaction score
- 18
I have almost finished a set of removable Cartridges that house different motor configs for a 4" little joe II
(Yea I admit it's been a excrutiatingly slow project)
I also plan to use them in a 4" Estes Maxi Pershing clone,using the Alien Enterprise reproduction Cone.
(and a beautifull cone it is! )from Ed Miller
the 4 threaded rods fit into a renforced mounting ring inside the Body tube and nuts are screwed on from the aft end with a magnetic nut driver
the coupler size was made from cutting a small section lengthwise from bt 101 till the resulting coupler fit snug inside the Body tube
this is a dry fit pic
from L to R
5 x 24mm
3 x 24mm
1 x29mm
(Yea I admit it's been a excrutiatingly slow project)
I also plan to use them in a 4" Estes Maxi Pershing clone,using the Alien Enterprise reproduction Cone.
(and a beautifull cone it is! )from Ed Miller
the 4 threaded rods fit into a renforced mounting ring inside the Body tube and nuts are screwed on from the aft end with a magnetic nut driver
the coupler size was made from cutting a small section lengthwise from bt 101 till the resulting coupler fit snug inside the Body tube
this is a dry fit pic
from L to R
5 x 24mm
3 x 24mm
1 x29mm