Starfire73
OpenRocket Wannabe
I've spent too much time and money on engines that have gotten older, absorbed moisture to varying degrees and not flown like they should or at all in some cases. Chuffing, low thrust, failure to ignite, etc.
I just got some Aerotech 24/40 reloads in and a few of them are likely not to launch until next year (2023). So, I put them in my Food Saver, on DRY/GENTLE setting and vacuum sealed them.
My main concern was that I did not want to cause any damage to the propellant grain or delay grain. I used the gentle setting in the hope that it would be less likely to deform the grain.
Anyone have any experience with that? Any thoughts, or tips?
I just got some Aerotech 24/40 reloads in and a few of them are likely not to launch until next year (2023). So, I put them in my Food Saver, on DRY/GENTLE setting and vacuum sealed them.
My main concern was that I did not want to cause any damage to the propellant grain or delay grain. I used the gentle setting in the hope that it would be less likely to deform the grain.
Anyone have any experience with that? Any thoughts, or tips?