Navajo
Active Member
- Joined
- Jan 12, 2004
- Messages
- 41
- Reaction score
- 0
I am shortly about to place an order with Fliskits for a Tres kit. I dont know if Jim Flis has sent Tres kits to anyone else in Australia before, but I am hoping that I might be the first to launch it down under...
My question is...
Is there any special launch equipment needed to get the three engines going at once?
Would using the estes electron beam launch controller (you know the basic estes starter kit controller) result in either of the following:
a: No ignition of any engine due to not enough power from the controller
b: Ignite maybe one or two engines only, therefore running the risk of impaling someones dog into a tree as they are walking through the park
I could really use some help here. Or is it obvious that i need some sort of 12V system. If so where do I go from here?
Thanks
My question is...
Is there any special launch equipment needed to get the three engines going at once?
Would using the estes electron beam launch controller (you know the basic estes starter kit controller) result in either of the following:
a: No ignition of any engine due to not enough power from the controller
b: Ignite maybe one or two engines only, therefore running the risk of impaling someones dog into a tree as they are walking through the park
I could really use some help here. Or is it obvious that i need some sort of 12V system. If so where do I go from here?
Thanks