I got a new rocket for christmas wich requires epoxy to asm. I never used this stuff what should I expect does it dry fast if I get it all over my hands will that be bad? The motor mount is 38mm I was thinking abount going down to 29 mm mount what is the process in asm. this. If I stick whith the 38 mm mount where are there places to buy motors for these just to get an idea of the prices. And last in the instructions it says this "Locate the
ring 1/2 from the end of the motor
tube and allow the epoxy to set." Does this mean set the epoxy bead 1/2 in down from the end in the instructions it looks to be right on the edge and the other side where the standard setting ring is it says to move it down 1/8" of the tube wich is noticable. am I correct and the pic is a little messed up or am I wrong and the pic is right? if your confused on this please go to
https://blastzone.com/pml/ the phobos kit and step 1.
ring 1/2 from the end of the motor
tube and allow the epoxy to set." Does this mean set the epoxy bead 1/2 in down from the end in the instructions it looks to be right on the edge and the other side where the standard setting ring is it says to move it down 1/8" of the tube wich is noticable. am I correct and the pic is a little messed up or am I wrong and the pic is right? if your confused on this please go to
https://blastzone.com/pml/ the phobos kit and step 1.