MGL
Active Member
I can not get results, followed the instructions but I must be doing something wrong.
To get the passkey, connect a USB-Serial cable (the same cable that’s used with all Eggtimer Rocketry products) to the 3-pin header as follows:
BLACK wire – GND WHITE wire – TX GREEN wire – not used
Using an ASCII terminal program such as TeraTerm or HyperTerminal, connect to the serial port at 115,200 baud, 8 bits, no parity, 1 stop bit. Now connect the battery on your WiFi Switch. You should see the following information:
(a few lines of garbage… part of the boot process)
WiFi Switch v1.02 SSID: WIFI_SW_F87A6E PASSKEY: 3718 6501
Note that there is a space between the first four digits of the passkey and the second four digits, that’s just to make it easier to read; when you actually enter the passkey don’t type the space.
I think my mistake is with TeraTerm setup. Can anyone coach me through step by step?
To get the passkey, connect a USB-Serial cable (the same cable that’s used with all Eggtimer Rocketry products) to the 3-pin header as follows:
BLACK wire – GND WHITE wire – TX GREEN wire – not used
Using an ASCII terminal program such as TeraTerm or HyperTerminal, connect to the serial port at 115,200 baud, 8 bits, no parity, 1 stop bit. Now connect the battery on your WiFi Switch. You should see the following information:
(a few lines of garbage… part of the boot process)
WiFi Switch v1.02 SSID: WIFI_SW_F87A6E PASSKEY: 3718 6501
Note that there is a space between the first four digits of the passkey and the second four digits, that’s just to make it easier to read; when you actually enter the passkey don’t type the space.
I think my mistake is with TeraTerm setup. Can anyone coach me through step by step?