AWright-001
New Member
Hello, I recently built an Eggtimer classic, and after getting it all assembled it gives the beep code of one high then one low beep, which should be a battery error.
However, with the board configured for variable voltage, and a good 2s lipo that read 7.4v, I am confused on how the battery could be an issue, if the error code truly is pointing to the battery.
I was able to get into the boards programming, however the flight profile did not save after powering off and reconnecting. All of the solder joints look okay, so I am not fully sure what could be wrong.
Any help would be greatly appreciated.
However, with the board configured for variable voltage, and a good 2s lipo that read 7.4v, I am confused on how the battery could be an issue, if the error code truly is pointing to the battery.
I was able to get into the boards programming, however the flight profile did not save after powering off and reconnecting. All of the solder joints look okay, so I am not fully sure what could be wrong.
Any help would be greatly appreciated.