kyled921
Rocketeer
- Joined
- Jul 20, 2015
- Messages
- 68
- Reaction score
- 0
So I got my new Eggfinder and had Connor assemble the unit. Everything looks great and I can't wait to try it out. However, I will need to add a few more things to the boards to fit my needs on the field.
- For the both the TX and RX, I plan on adding these battery connectors for a LiPo.
- For the RX, I plan on adding the HC-06 Bluetooth module by adding two pins to the board at the 3.3V and GND connections (normally LCD?). I plan on using these pins, breaking off two I guess, then soldering them on.
- For soldering, does anyone knnow if these are compatible with the RX/TX board? I know the manual says low temp and no flux? Never soldered anything like this before so I am jumping a little bit into it.
- 60W Soldering Iron
- Kester 245 Solder
Any advice on best approach/materials is welcome. I probably should have thought of all this when it was with Connor but I got distracted with side projects and figured I could learn some new skills with minimal risk on these last few items.
Thanks TRF!
- For the both the TX and RX, I plan on adding these battery connectors for a LiPo.
- For the RX, I plan on adding the HC-06 Bluetooth module by adding two pins to the board at the 3.3V and GND connections (normally LCD?). I plan on using these pins, breaking off two I guess, then soldering them on.
- For soldering, does anyone knnow if these are compatible with the RX/TX board? I know the manual says low temp and no flux? Never soldered anything like this before so I am jumping a little bit into it.
- 60W Soldering Iron
- Kester 245 Solder
Any advice on best approach/materials is welcome. I probably should have thought of all this when it was with Connor but I got distracted with side projects and figured I could learn some new skills with minimal risk on these last few items.
Thanks TRF!
Last edited by a moderator: