I did a quick design on a basic box for an Eggfinder LCD this weekend. I just wanted a small no frills box and didn't want to take the time to hack up a blank project box, so I 3D printed one. It does not have room for a voice module or base GPS module. It is for the RevB2 hardware and a 7.4v mjxrc Lipo battery, although a 9v battery should fit.
It needs twelve 3mm screws (M3-10) and six 3mm x 10mm standoff spacers to hold it together. It also requires two toggle switches (power and mute) with 6mm hole and a momentary push button (program) also ~6mm.
Below is a Thingiverse link that has the STL files and source Sketchup files are included, so you can easily modify using the free online version of Trimble Sketchup.
https://www.thingiverse.com/thing:5599013/files
Enjoy,
Mike
It needs twelve 3mm screws (M3-10) and six 3mm x 10mm standoff spacers to hold it together. It also requires two toggle switches (power and mute) with 6mm hole and a momentary push button (program) also ~6mm.
Below is a Thingiverse link that has the STL files and source Sketchup files are included, so you can easily modify using the free online version of Trimble Sketchup.
https://www.thingiverse.com/thing:5599013/files
Enjoy,
Mike