mtnmanak
™
- Joined
- May 5, 2020
- Messages
- 2,063
- Reaction score
- 2,783
Moving on to the forward fins. Using the medium size guillotine fin jig for the forward fins. Makes short work of it. Setting the fins in with 5-min quick cure epoxy since the main structural bond will come from the epoxy I inject later on. Procedure is simple as lining up the body tube in the jig (the lines I drew down the BT earlier make this very easy), getting the guides aligned properly, buttering the root edge of the fin and seating it in the slot. Just make sure the fin is securely against the MMT. Going to allow each fin to cure for about 20 min before rotating the body, so will be back with an update later after I finish the three forward fins.