• If you have bought, sold or gained information from our Classifieds, please donate to Rocketry Forum and give back.

    You can become a Supporting Member which comes with a decal or just click here to donate.

Custom CF Fins

TRFfan

Well-Known Member
Joined
Aug 5, 2015
Messages
1,211
Reaction score
2
Hi,

Is there anyone on the forum who could make a good pair of CF fins? I am looking for 1 mm fin with a full airfoil and a measurement of 1mm in diamiter. Pm me and Ill send you the measurements. Thanks. :)
 

TRFfan

Well-Known Member
Joined
Aug 5, 2015
Messages
1,211
Reaction score
2
You've been told this before you must not remember.
Carolina Composites will do your custom work.

Yes but he only has 0.8 mm stock plate to make the fins and I dont think they will hold up. 1 mm is the minimum thickness I am going for.
 

REK

Well-Known Member
TRF Sponsor
TRF Supporter
Joined
Feb 21, 2012
Messages
3,093
Reaction score
109
Location
El Paso, Texas
These fins are small at 2" root cord and 3/4" fin span correct? I have some small carbon fabric pieces that should be enough for me to make you the sheet. Now as far as making the airfoils I can not do them perfectly as you may want them to be.

PM me if you want to go through with this.
 

FredA

Well-Known Member
Joined
Jan 18, 2009
Messages
2,849
Reaction score
1,022
Such tiny fins....
Can you tell us how you determined that 0.8mm was insufficient, but 1mm would be fine?
 
Top