Have never had this happen before (did have a burn through, but not this). Brand new 29-180 case. Used an H238T, flight was perfect. Didn't notice anything wrong until I got home and noticed the slight blister on the case (in the photo the forward closure is there, but this was after the aft end of the motor when it occurred) when I was unloading it to clean. You can just barely feel the blister, and you can see some discoloration inside. I had made sure to grease the outside of the liner tube well after my last issue. The liner was burnt in a small triangular pattern extending up from the nozzle to this area (forgot to get a picture of that), but was otherwise intact, as as the aft o-ring and the nozzle itself.
So, question: is the case toast now? (my suspicion is that is the case, but I figured I would ask before I toss it since Ive never seen this before with my 38 mm HW)
So, question: is the case toast now? (my suspicion is that is the case, but I figured I would ask before I toss it since Ive never seen this before with my 38 mm HW)