Boyce Aerospace Pershing 1a

Discussion in 'Low Power Rocketry (LPR)' started by EvryThngIsAOk, May 28, 2019.

Help Support The Rocketry Forum by donating:

  1. May 28, 2019 #1

    EvryThngIsAOk

    EvryThngIsAOk

    EvryThngIsAOk

    Well-Known Member

    Joined:
    Oct 16, 2016
    Messages:
    123
    Likes Received:
    28
    Just finished my Pershing 1a from Boyce Aerospace.
    BT-80 based, kit build fairly quickly.
    The 3 piece nose comes with the majority of the sanding already done. The cable covers, fins and charge retainer require more sanding but not so much that it becomes a pain.
    24mm Motor mount had two 3D printed rings, a screw on engine retainer and a unique tie down space of top of the upper ring to attach the kevlar shock cord mount in a loop that should eliminate any tube zippering.
    The Boyce’s include both launch lugs and rail buttons along with an extra of each fins in case you damage at launch. Decals are StickerShock and Marks typical quality.
    Super kit and nice to have a Pershing in this scale.

    Finished kit is 27 1/4” tall and weighs 6.6 ounces with out engine. Designed to fly on E-9.
     

    Attached Files:

    Last edited: May 28, 2019
    MikeT, pondman and James Harechmak like this.

Share This Page

Group Builder