Quantcast

Binder Design AV Bay info...

The Rocketry Forum

Help Support The Rocketry Forum:

K'Tesh

OpenRocket Chuck Norris
TRF Supporter
Joined
Mar 27, 2013
Messages
14,414
Reaction score
1,013
Ok, I'm creating drop-in Binder Design AV bay/Dual Deploy bays for my .ork files. Problem is, I don't have data on the nuts and washers. I'm looking for dimensions as well as weights of the parts.


Binder Design 4 inch Dual Deploy Kit for Long Rockets.png

I could also use info on the screw switch (which will most likely be simmed with a fin), and (as you can see) I'm even trying to sim PVC end caps for the charge wells (though they are not included in the kit).

Edit... I knew I could do better than what you see above... So, I went back to work on it...



I might not be able to create a completely round eye bolt... Then again... I AM AN OPENROCKET NINJA!!! (I can sneak up on it)

Thanks!
Jim
 
Last edited:

K'Tesh

OpenRocket Chuck Norris
TRF Supporter
Joined
Mar 27, 2013
Messages
14,414
Reaction score
1,013
I've got what I need as far as dimensions... Thanks to Mike and David!

I still need the weights to make my sim even more accurate, but it's a lot closer than anything else I've seen so far.
 
Last edited:

Steve Shannon

Well-Known Member
TRF Supporter
Joined
Jul 23, 2011
Messages
6,467
Reaction score
3,133
Location
Butte, Montana
You should consider putting what you know about Open Rocket into a book. Seriously.


[emoji1010] Steve Shannon [emoji1010]
 

Forever_Metal

JustAnotherBAR
Joined
May 21, 2016
Messages
493
Reaction score
37
Location
Madison, AL
Ok, I'm creating drop-in Binder Design AV bay/Dual Deploy bays for my .ork files. Problem is, I don't have data on the nuts and washers. I'm looking for dimensions as well as weights of the parts.


View attachment 294618

I could also use info on the screw switch (which will most likely be simmed with a fin), and (as you can see) I'm even trying to sim PVC end caps for the charge wells (though they are not included in the kit).

Edit... I knew I could do better than what you see above... So, I went back to work on it...



I might not be able to create a completely round eye bolt... Then again... I AM AN OPENROCKET NINJA!!! (I can sneak up on it)

Thanks!
Jim
KT,

where's the files?\

looks good!!!

fm
 
Top