N Not Quite Nominal Well-Known Member Joined Jun 20, 2018 Messages 153 Reaction score 171 May 6, 2020 #31 Aerofoam Here's a little one for UAVs
E ether Well-Known Member Joined Oct 22, 2019 Messages 236 Reaction score 122 Aug 4, 2020 #32 mbeels said: And from the outside, without shock cords attached. The main sits in the tube, and the cap is held down by the releasable eye bolt. View attachment 415249 Click to expand... have you tested it with weights simulating the drouge pulling on it? if there too much friction for the servo to pull it, you can try a 3 ring https://www.aerofoam.com/3-ring-release.html I have this release mechanism, was going to try using it for my L3 but decided to stick to proven BP charges. Also, check out the release mechanism on this one, personally think this is probably the best method, geared motor and the bearings to aid release https://www.propulsionlabs.com.au/Pyroless_Release/
mbeels said: And from the outside, without shock cords attached. The main sits in the tube, and the cap is held down by the releasable eye bolt. View attachment 415249 Click to expand... have you tested it with weights simulating the drouge pulling on it? if there too much friction for the servo to pull it, you can try a 3 ring https://www.aerofoam.com/3-ring-release.html I have this release mechanism, was going to try using it for my L3 but decided to stick to proven BP charges. Also, check out the release mechanism on this one, personally think this is probably the best method, geared motor and the bearings to aid release https://www.propulsionlabs.com.au/Pyroless_Release/
