SOLD 98mm CF Thicker wall tubes

The Rocketry Forum

Help Support The Rocketry Forum:

REK

Sponsor
TRF Sponsor
Joined
Feb 21, 2012
Messages
2,877
Reaction score
69
Alright TRF, I have here two 98mm tubes that turned out a little bit beefier, I mis-counted the layers and threw in one extra layer.

One is 34.5” long and the other is 24.75” long. Tg 250F and both have an ID of 3.9” +\- 0.005”. If you want OD details, let me know.

41F64714-7780-4DC7-8586-8090C2BCC8FA.jpeg

I am asking $165 for the 34.5” and $119 for the 24.75” one, plus shipping.

Thank you for your interest and support.
 

REK

Sponsor
TRF Sponsor
Joined
Feb 21, 2012
Messages
2,877
Reaction score
69
I forgot weight details, the longer tube weighs in at 778 grams and the shorter tube at 562 grams

OD measures at 4.05”
 

REK

Sponsor
TRF Sponsor
Joined
Feb 21, 2012
Messages
2,877
Reaction score
69
Bump, I forgot to include that I will coat with epoxy and sand smooth as possible the tubes for an additional $40, $20 for a single tube.
 

REK

Sponsor
TRF Sponsor
Joined
Feb 21, 2012
Messages
2,877
Reaction score
69
Price drop of $20 to each tube
 

REK

Sponsor
TRF Sponsor
Joined
Feb 21, 2012
Messages
2,877
Reaction score
69
Dropping price to $116 for the large one and $84 for the smaller one, total of $200 for both.
 

MikeyDSlagle

Well-Known Member
Joined
Dec 17, 2013
Messages
2,496
Reaction score
472
You say coat with epoxy. What is the current finish of the short tube? And how is the fit with other vendor nose cones?
 

REK

Sponsor
TRF Sponsor
Joined
Feb 21, 2012
Messages
2,877
Reaction score
69
You say coat with epoxy. What is the current finish of the short tube? And how is the fit with other vendor nose cones?
Basically the finish is still a little rough with the heat shrink tape ridges that get left behind. Also (an issue I am still trying to fix) the circulation and temperature regulation is not that good on my oven and as a result the resin did not flow properly in some areas and resulted in pin holes, here is a picture

B5E64991-781C-4410-9320-93FE9A19305E.jpeg

Most of the short tube is not that rough, but still requires work to get it really smooth. Hence why I opted to coat it and smooth it out for you for an additional fee of course.

as for the fit of nose cones, I have sold a tube to someone in the past using this exact same mandrel and it fit just fine. Just the OD will not match on this particular tubing.
 

Latest posts

Top