Sold 7.5 Inch Fiberglass Nose Cone

[bobchmara]

This is a used nose cone I acquired probably 15 years ago or more and I've never used it. It'll need some prep work before finishing. It's about 29.5" tall (not including shoulder) and the shoulder is just over 3". There's a paint chip on the side about 3/8" in size. No bulkhead. Asking $125 plus shipping which I'll cap at $50. I'm open to offers.

 

[jmasterj]

Do you know the OD just above the shoulder and the shoulder OD? Or have you fitted it to LOC or PML 7.5" tubing?

 

[bobchmara]

This came from a 1/2 scale Patriot. I believe it was a PML phenolic kit but it's been a long time and I'm not 100% sure about that. I don't have either of the OD measurements, nor do I have a caliper large enough to measure directly. I can measure the circumference and do the math but I don't know if that will provide the accuracy you need.

 

[sharkbait]

This is a used nose cone I acquired probably 15 years ago or more and I've never used it. It'll need some prep work before finishing. It's about 29.5" tall (not including shoulder) and the shoulder is just over 3". There's a paint chip on the side about 3/8" in size. No bulkhead. Asking $125 plus shipping which I'll cap at $50. I'm open to offers.

PM sent

 

[rmpitzer]

Is this still available?