3D Printing 3D Printing Wall of Shame

[cwbullet]

Ok,

This is self-descriptive. Post your worst failed print.

 

[cwbullet]

AV Bay Sled: Not

 

[James Harechmak]

My first 3D printer should be here this afternoon. I'm sure I'll have a mess or a dozen to post by Monday.

 

[Banzai88]

View attachment 378566

AV Bay Sled: Not

ouch

 

[TurbulentSphere]

It is not the worst (don't have a picture of that one), but the stupid fins on Peanut caused all sorts of problems. Took half a dozen tries to get it to stop popping off the bed.

 

[cwbullet]

It is not the worst (don't have a picture of that one), but the stupid fins on Peanut caused all sorts of problems. Took half a dozen tries to get it to stop popping off the bed.

I hate when the extrude knocks over the print. Especially when you are that close to printing.

 

[cwbullet]

Yet another fail:

 

[James Harechmak]

Left the house after the first few layers looked like it was going well. Got back 3 hours later to this. I think my dogs had something to do with this fail.

 

[cwbullet]

Fails can be educational/

 

[Zeus-cat]

View attachment 378566

AV Bay Sled: Not

Av Bay sled as designed by Picasso

 

[Landru]

Short of extremely nondescript piles of spaghetti...

 

[cwbullet]

I am always amazed at the artwork my printer can deliver.