Search results

I lost a 38mm motor mount rocket (reloadable). Will further pictures of found rockets be posted here?

This is a very useful thread, especially those considering building eggtimers. Having built about 20 kits with about 90% success (including 2 TRS and a Quasar build), I have only a few pieces of advice to add: Take your time and be well rested when you build/solder. BECAUSE..unsoldering is a...

I am heading today to MDRA in Maryland (higgs field)..it is a 2 hour ride but a nice field. I do wish there was an accesible field in the Lehigh valley to do high power (and by extension low power) Anyway in the future if there is anyone local wanting a ride,I can provide.

Hello NukeHavoc, I am responding to this thread as I am close by in Allentown.

Hi Kev I am a BAR from Allentown ( now level 3 Tripoli) I fly with Metra and Mdra with occasional trips to Geneseo NY.

I live in Allentown and I am planning on going. I can pass by Pittston and pick you up.

I am flying to LDRS 39 from the east coast.If anyone nearby is driving and would be willing to take a few smaller rockets,I would be happy to defray their costs. I live in eastern Pa.

Did you go into device manager and see if the cable is actually connected on com3?

I Believe I live down the road from you. (I live right off Orefield road between the high school and junior high)

The super dx3 is a good rocket for level 1 cert. find a club, build the rocket and get certified.

Exactly...I used the table to load the powder...my electronics were connected and my ematches were connected,but no powder was in the rocket..the worst that could happen at my car or at thr rso table is the ematch could light.Is there a problem with this work process...enlighten me.

Hi Bill, I am definitely interested and fly with MDRA. I live in Allentown, Pa.I am not sure how to PM you?

Perhaps I am off-base but we are acting as if altimeters and switches (and even e-matches) are the main issue,when it is the Gun Powder that is the concern.If this is the case,then perhaps ALL loading of gun powder should be done at an isolated spot,where the risk is rightly assumed by the TRA...

The club set up the table-I went where they told me.(It seemed safe for everybody except me:))

My first post.I sent this letter to Cris Erving; hi Cris, Following the long discussion at the rocketry forum. this last Saturday at MDRA (Maryland). I have a 20 lb rocket with 2 Quantums. After discussion with RSO: I prepped the rocket , connected the batteries and checked continuity with...

Is there documentation available for the 33 (pdf etc.) and the tilt module?