Search results

The Rocketry Forum

Help Support The Rocketry Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. maddmaxx11

    Min speed off rail to be stable?

    What would be a minimum speed in ft/sec or mph off the end of the rail for a stable rocket(2+ calibers etc.) to be safe?
  2. maddmaxx11

    Old K185 reloads

    I picked up an Aerotech 1706 motor locally and got 3 K185 reloads that were in motors ready to fly for 4 years. i have not taken the grains out of the liner yet but the top and bottom looks fine (no swelling) but has some light oxidation on them. I guess my question is if I scuff these lightly...
  3. maddmaxx11

    Motor Case covers

    Who sells the motor case covers that are inexpensive to protect them in storage?
  4. maddmaxx11

    Open Rocket and Hybrids

    In Open Rocket 15 when I add a hybrid motor like SkyRipper does the total motor weight include the NitrouOxide weight or just the hardware and fuel grain? Just trying to figure if I need to add a mass where the nitrous is to be able to show the right CG when ready to launch.
  5. maddmaxx11

    3D Printing Printing safety

    Where does everyone have their printers? I read that breathing the fumes is very bad for you even with PLA and worse with ABS etc. I only run 1 printer and it is in a large room in the house. When printing ABS I put it in the garage so I would not be around it while printing but it is cold out...
  6. maddmaxx11

    Found 54mm SkyRipper hardware

    Looking for complete 38mm and 54mm motors.
  7. maddmaxx11

    Found Aerotech 54mm Hardware

    Looking for good used Aerotech 54mm motor hardware.
Back
Top