Search results

I asked for tubular kevlar NOT nylon.

Where can I buy 5/8" tubular kevlar for my shock cords?

Thoughts and Comments on Who Sabotaged the Russian Nord Stream 1 & 2 Pipelines!!

I have about 15 packages inbound for me from around the US that have been already shipped. Out of the fifteen 10 are from the post office and they are the only ones running late. Seems to wonder why the post office is losing money!!

54mm thru 98mm

Not myself

Here is a poll to determine which nozzle composition you prefer?

Found my under extrusion problem. First was the thermistor. I had some Chinese thermistors that the resistance was 160K ohms and not around 100K ohms. The firmware uses #5 thermistor tables based on 100K ohms. This made the temps read 15-25C hotter than they actually were. Second was the...

Just checked 3 brand new thermistors and the resistance was around 94K ohms each. The thermistor tables in the firmware for this use tables based on 100K ohms. My thermistor in the printer measured 160K!! I think that might be the culprit. I will check.

I am chatting with prusa right now. I am on my third tech. I spent about 4 hours with a total of 5 techs trying to get this problem resolved. In the end nothing was accomplished. Still have my under extrusion problem. PLA is problematic but anything else forget it. I hope this new...

I talked to prusa and they said it would equate to a 36w heater instead of 40w. No big deal.

It is not resistance I measured. I measured temperature with a temp probe attached on the voltmeter.

I just checked the heater block with a Fluke voltmeter/temp probe. I double checked the voltmeter with a Fluke IR laser temp gauge to make sure it was accurate. voltmeter IR laser hot coffee 62C 61.8C ice water 5C...

What Prusa MK3 firmware version do you feel the most stable and with less problems?

Has anyone had heat creep on a Prusa MK3? If so, how did you fix the problem?

Does anyone know what the resistance is for the standard Prusa Mk3 hotend thermistor and 40W heater?

Thanks.

Where is that located?

This is another question using open rocket. I set up my rocket using a main chute ejection at 500 feet. I do my motor tests and all is fine. I save the file. But when I reopen the file all that info is gone and I have to reset the 500 feet again. Is there a default for electronic altimeter settings?

After removing the Raspberry 3B+ from printing and using only the SD card I have had about 20 perfect prints. I have ordered another power supply from Amazon that has high marks from youtubers. https://www.amazon.com/gp/product/B01N336XEU/ref=ppx_od_dt_b_asin_title_s00?ie=UTF8&psc=1 I will check...